Table des Matières
Publicité
Maintenance
–
First pull out the plug from the mains be-
fore carrying out any tasks on the ma-
chine.
–
To avoid risks, all repairs and replace-
ment of spare parts in the machine may
only be carried out by the authorised cus-
tomer service personnel.
Start up
Description of the Appliance
1
Polishing head
2
Foot switch for strut release
3
Strut
4
Power cord with plug
5
Storage, power cord
6
Handle
7
Suction hose
8
Cloth bag
9
Filter bag
10 Storage compartment for polishing pads
11 Polishing pads
12 Pad holder
13 Suction hose connection
14 Transport rolls
15 Attachments for mains cable (4 ea.)
16 Transport lock
Remove transport lock
Illustration
Remove the transport locks the first time
you use and before using the appliance by
pulling them off.
Assemble the strut and attach it
Illustration
Assemble both parts of the strut and se-
cure with the enclosed screw and nut.
Insert the entire strut into the polishing
head and attach with a screw.
Note: Here, take into account the location
of the mains cable.
Illustration
Press the mains cable into the attach-
ments and tension it.
Connect suction hose
Illustration
Insert the straight end of the suction hose
into the polishing head, insert the bent
end into the strut connection.
Inserting the cloth bag
Illustration
First, push the upper part of the cloth bag
into the intake until it locks.
Then attach the bottom part to the strut
using the Velcro pad.
Inserting a filter bag
Illustration
Open the zipper of the cloth bag.
Insert the filter bag and slide the carton
with the opening over the support until it
locks into place. Recheck the correct po-
sitioning of the filter bag.
Close the zipper on the cloth bag.
Insert pad holder
Illustration
Place the appliance on the floor so that
the polishing head is positioned perpen-
dicular to the surface.
Simply press the pad holder into the in-
take. Ensure that the noses of the pad
holders lock well into the intake.
To remove the pad holders, simply pull
them off.
Insert the polishing pads
Illustration
Install the polishing pads on the pad hold-
ers and ensure that they are centered
properly.
To remove the polishing pads, simply pull
them off.
Storing the polishing pads
The polishing pads can be stored in a sep-
arate compartment in the bottom part of
the cloth bag.
English 9
9
English
Publicité
Table des Matières
