Removing Of Waste Material - Bartscher GWTH1 Mode D'emploi

Failure
The burner does
not operate
The ignition
flame is not
maintained
The cases listed above are for the reference and example only. In order to remove
such problems stop the operation of the device until the problem is solved. Contact
the service or vendor. Prepare the article number and the serial number, shown on
the rating plate on the back wall of the device.

8. Removing of waste material

The worn out device should be removed according to the national and local regulations.
To do this, contact the professional company or with the waste removing department of
the local authorities.
CAUTION!
In order to exclude the incorrect use and connected danger prevent
the start-up of the worn out device before its removing and transport it
to the appropriate collection point.
Bartscher GmbH
Franz-Kleine-Str. 28
D-33154 Salzkotten
Germany
- 48 -
Cause
• damaged gas shut-off valve
• contaminated thermocouple
• the thermocouple does not
indicate voltage (mV)
• the thermocouple is loose
• the thermocouple magnet is
damaged
Solution
• check and replace
• check and clean with small
steel brush
• check and remove
• check and remove
• check and replace
phone: +49 (0) 5258 971-0
fax: +49 (0) 5258 971-120