Product Use; Installation Concerns; Handle Adjustment; Installation With Base - Nuna Pipa Icon Instructions Pour L'installation

Product Use

Installation Concerns

This PIPA icon enhanced child restraint with the Base is
suitable for vehicle seats with i-Size ISOFIX anchor points.
(1)
DO NOT place rear-facing PIPA icon enhanced child
restraint on front seat with air bag. Death or serious injury
may occur. (2) Please reference vehicle owner's manual for
more information.
DO NOT install this PIPA icon enhanced child restraint on
vehicle seats that face sideways or rearward with respect to
the moving direction of the vehicle. (3)
It is recommended to install this PIPA icon enhanced child
restraint on the rear vehicle seat. (4)
DO NOT install this PIPA icon enhanced child restraint on
vehicle seats unstable during installation.

Handle Adjustment

1
The handle of the PIPA icon enhanced child restraint can
be adjusted to 3 positions.
Rocking position. (5) -1
Baby chair position. (5) -2
Position for car, hand or stroller transportation. (5) -3
2
To adjust the handle positon, squeeze handle buttons on
both sides to release it. (6) -1
3
Rotate handle until it clicks into any of the 3 positions.
(6) -2
13 PIPA icon Instructions

Installation with Base

1
Unfold the load leg from storage compartment. (7)
2
Fit the ISOFIX guides with the ISOFIX anchor points. (8)
The ISOFIX guides can protect the surface of the vehicle
seat from being torn. They can also guide the ISOFIX
connectors.
3
Rotate the ISOFIX connectors 180 degrees until they are
pointing in the direction of the ISOFIX guides. (9)
4
Line up the ISOFIX connectors with the ISOFIX guides,
and then click both ISOFIX connectors into the ISOFIX
anchor points. (10)
Make sure that both ISOFIX connectors are securely
attached to their ISOFIX anchor points. There should be
two audible clicks and the colors of the indicators on the
both ISOFIX connectors should be completely green.
(10) -1
Check to make sure the base is securely installed by
pulling on the both ISOFIX connectors.
5
After placing the base on the vehicle seat, extend the
load leg to floor (11). When the load leg indicator shows
green means it is installed correctly, red means it is
installed incorrectly. (11)
The load leg has 24 positions. When the load leg
indicator shows red this means the load leg is in the
wrong position.
Make sure the load leg is secure by pressing down on he
front of the base.
To shorten the load leg, squeeze the load leg release
button and pull the load leg upwards. (11)-1
The completely assembled base is shown as (12)
PIPA icon Instructions 14