Installation Without Base - Nuna Pipa Icon Instructions Pour L'installation

4
Tighten the shoulder harness straps by pulling the
adjustment webbing. (26)
Make sure the space between the child and the
Shoulder Harness Straps is about the thickness of one
hand.
Canopy
1
Unzip the zipper behind the front canopy bow. (27)
2
Pull the canopy out of the compartment. (28)
3
Attach the magnets on each corner to the front of the
PIPA icon enhanced child restraint. (29)
4
The zipper on the back of canopy can be opened for
ventilation. (30)
Detach Canpoy Seat Pad
1
Detach the snaps to disassemble the canopy, press the
button in the canopy mount and pull the canopy bow
out. (31)
2
Pull the fastening pieces underneath the edge of the
seat out. (32)
3
Press the red button to disengage the buckle. (23)
Remove the Infant Insert and crotch strap.
4
Detach the elastic band on the head support, and then
remove the head support.
5
Remove the seat pad from the adjustment button as
shown in. (33)
6
Remove the seat pad from the Stroller release button as
shown in. (34)
17 PIPA icon Instructions

Installation without Base

1
DO NOT install this PIPA icon enhanced child restraint
on vehicle seats with Lap Belts. (35)
2
This PIPA icon enhanced child restraint is suitable
for vehicle seats with a 3-point Retractor Safety Belt
(without base) only. (36)
3
Place the PIPA icon enhanced child restraint onto the
vehicle seat where you wish to put it. Pull the vehicle
safety belt out and lock it into the vehicle buckle, sliding
the vehicle lap belt into the side guides of the PIPA icon
enhanced child restraint. (37)
The PIPA icon enhanced child restraint can not be used
if the vehicle safety belt buckle (female buckle end)
is too long to anchor the PIPA icon enhanced child
restraint securely. (37)
4
Slide diagonal belt into the rear guide. (38)
5
Pull the vehicle shoulder belt to fasten the PIPA icon
enhanced child restraint tightly and securely. (39)
6
Level line on carrier must be level to the ground when
the PIPA icon enhanced child restraint is installed. (41)
Tension the vehicle safety belt as much as possible,
checking that it is not loose or twisted.
After installing the PIPA icon enhanced child restraint,
always check that the vehicle belts are routed correctly
and securely fastened into the vehicle buckle. (40)
Aeroplane Installation
Note that safety of the child for not complying with the
installation and instruction manual is not guaranteed.
Note that the installation of the infant carrier on an aircraft
PIPA icon Instructions 18