Height Adjustment; Securing Child - Nuna Pipa Icon Instructions Pour L'installation

The ISOFIX connectors must be attached and locked
onto the ISOFIX anchor points. (12)-1
The load leg must be installed correctly with green
indicator. (12)-2
6
To remove the base, press the secondary lock button
(13)-1 first and then the button (13)-2 on the latch
connectors before removing the base from the vehicle
seat.
7
Press the ISOFIX releasing button to fold the ISOFIX.
(14)
8
Push the PIPA icon enhanced child restraint down into
the base (15), if the PIPA icon enhanced child restraint is
secure, the PIPA icon enhanced child restraint indicator
shows green. (16)
Pull up on the PIPA icon enhanced child restraint to be
sure it is securely latched into the base.
9
To release the PIPA icon enhanced child restraint, pull
the enhanced child restraint up while squeezing the
PIPA icon enhanced child restraint release button. (17)

Height Adjustment

for Head Support and Shoulder Harnesses
Check that Shoulder Harness Straps are set at the proper
height. Please choose the proper pair of shoulder harness
slots according to the child's height.
Shoulder Harness Straps must go into the harness slots
nearest to your childs shoulders (18), but not above the
shoulder line. (19)
If the Shoulder Harness Straps are not at proper height,
the child might be ejected the PIPA icon enhanced child
restraint if there is a crash.
15 PIPA icon Instructions
Squeeze the head support adjustment lever (20),
meanwhile pull up or push down the head support until
it snaps into one of the 7 positions. The head support
positions are shown as (21).

Securing Child

Use Infant Insert
Detach the snaps on
the head support to
remove the head
portion of the insert.
We recommend
using the full infant
insert while the baby
is under 60 cm or
until they outgrow
the insert. The infant Remove the infant
insert cushion by
insert increases side
detaching the snaps
impact protection.
to allow more space
when the infant does
not fit comfortably.
After the child is placed into the seat, check whether the
Shoulder Harness Straps are at proper height.
1
While pressing the adjustment button located at the
front of the PIPA icon enhanced child restraint, pull
completely the two Shoulder Harness Straps of the PIPA
icon enhanced child restraint. (22)
2
Unlock the buckle of the harnesses by pressing the red
button. (23)
3
Place the child into the PIPA icon enhanced child
restraint and lock the buckle. (25)Please refer to. (24)
Remove the head
support portion of
the infant insert
when the child's
head no longer fits
comfortably.
Remove the body
portion of the infant
insert when the
infant's shoulders no
longer fit comfortably.
1
The cushion can
be used separately
without being
attached to the
insert to bolster
2
the infant's back
for more comfort.
PIPA icon Instructions 16