emerio FN-111453 Mode D'emploi page 7

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
b. How to start body sensor?
The body sensor will be activated automatically after the appliance is turned on. The LED lights
of angles will be flashing by turns.
Long touch button "
LED lights of angles will be flashing by turns.
Continuously touch button "
c. How does the body sensor work?
The fan will work in 360 degree oscillation first after the body sensor started; it will send out
beep sounds when get a signal back. After figuring out the suitable angle, the unit will swing
according to this angle for the following work.
If no signal is detected, the unit will detect again with oscillating 360 degree to find the signals.
If more people signals appear after the angle already fixed, users should touch the button to
start the sensor again.
d. Detecting distance: Best within 2m from the fan
2) Vertical oscillation: Touch button "
approximately 80°. Touch the button again, the vertical oscillation function is deactivated.
6.
This appliance is initially set in mode "Normal". You can also touch button "
between "Normal", "Natural", "Sleeping" and "ECO". The LED indicator changes accordingly. (No LED light
for the "Normal" mode.)
1) Normal: This appliance is initially set in mode "Normal". Under this mode, the fan is working at low wind
speed. You can also touch button "
Low ...".
2) Natural: Touch button "
touch button "
" for approximately 3 seconds to start the body sensor function. The
" to shift angles. The body sensor starts working after 360°.
" to activate vertical oscillation function. Oscillation angle:
" to set your desired wind speed at "Low → Medium → High →
" to choose the natural mode. LED light of "
" to choose your desired wind speed as follows:
- 6 -
" to switch the mode
" will be on. And then
/
/
.

Publicité

Table des Matières
loading

Table des Matières