Front Panel - Apex Domus 4 Instructions D'utilisation

English
2.3

FRONT PANEL

English
1. Pressure Adjust Levels
Pressure adjust levels controls the air pressure output. When turning up (
pressure will increase. Vice versa (
support the heavier weight patient. In order to find the correct pressure setting: First inflate the
mattress to max pressure level, have the patient lie on top of the mattress, then decrease the
pressure gradually until the patient feel most comfortable without bottoming out. Have the
caregiver insert palm facing up and place between patient's buttock's area and static cell.
Should the palm able to touch patient's buttock, increase the pressure until the skin is least 1/2"
inch away from the palm. Always leave at least 1" inch space between patient's buttock areas to
the static cell under to prevent bottoming out.
2. Mode
A. Max Firm
It will be forced to execute every time the power switch is turned on. This insures the pump
is able to reach its maximum operating pressure. Once the max pressure level is reached,
the pump will automatically switch into alternating mode. User can also use this function as
full mattress inflation while ingress/egress the patient for better support. There is a 20 min
auto-recovery mode back to alternating cycle to ensure patient always getting best therapy
possible.
B. Alternate
In Alternate therapy mode, the mattress system will alternate every 10 minutes.
C. Static
Press the button to suspend alternating function, if needed. The pressure inside of air tubes
will be adjusted to the same softness. Press the button again; it will switch back to
alternating mode. Under the static mode, cell pressure level will be lowered compare to the
same pressure level from alternating mode.
2
3
) for decreasing air pressure. Higher-pressure output will
5
1
4
), the output