Installation; Safety; Appliance Description; Preparations - AEG Huz 5 OKO Comfort Utilisation Et Installation

INSTALLATION

6. Safety

Only a qualified contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
6.1 General safety instructions
We guarantee trouble-free function and operational relia-
bility only if original accessories and spare parts intended
for the appliance are used.
6.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regula-
tions and instructions.

7. Appliance description

The appliance is intended to heat cold water and supply
it to a single draw-off point.
Huz 5 ÖKO Comfort
The open vented (non-pressurised) appliance is only suit-
able for undersink installation.
Hoz 5 Comfort
The open vented (non-pressurised) appliance is suitable
only for oversink installation.
7.1 Standard delivery
The following are delivered with the appliance:
◦ Wall mounting bracket
7.2 Required accessories
The following taps are available as accessories for open
vented operation:
Huz 5 ÖKO Comfort
AHEu 50 WT - Mono lever mixer tap for washbasins
AHEu 50 S - Mono lever mixer tap for sinks
AHu 50 - Mixer tap with pivoting spout
AHu 51 - Twin-lever mixer tap with pivoting spout
AHS 50 - Sensor tap
Hoz 5 Comfort
AHo 50 - Twin-lever mixer tap with pivoting spout
Installation – for qualified contractors

8. Preparations

» Flush the water line thoroughly.
Water installation
A safety valve is not required.
Taps/valves
Sealed unvented taps are not permitted.
» Install an open vented tap.
8.1

Installation site

Material losses
!
Install the appliance in a room free from the risk of
frost.
Material losses
!
Mount the appliance on the wall. The wall must have
a sufficient load-bearing capacity.
Note
Ensure that the appliance is freely accessible for
maintenance work.
Always install the appliance vertically and near the draw-
off point.
8.1.1 Huz 5 ÖKO Comfort - Undersink installation
Material losses
!
The Huz 5 ÖKO Comfort is designed exclusively for
undersink installation. The water connections of the
appliance point upwards.
15