Lincar Ilaria 703T-G Instructions D'usage Et Entretien page 50

DEFECT
Not regular draft
Too much dark
fumes from the
exhaust
Fume escape from
the stove
Condensate close to
the stove
Condensate on the
fume exhaust tubes
Every intervention has be done from qualify staff !
CORISIT S.r.l. is not responsible for damages to things or people due to a wrong installation,
equipment tampering, improper use, bad maintenance or no observation of normative in
force.
If considerate appropriate, CORISIT S.r.l. reserves the right to make modifications without
notice and in every moment.
Some particulars and accessories illustrated in this handbook are not mass produced item so
its extra costs are to check at contract release.
CAUSE
− Flue / exhaust fumes
unsuitable or dirty.
− Stove is dirty inside.
− Stove light on with green
wood/ too humid.
− Fume exhaust partially
obstructed.
− The fire/ash door is open
while the fire is burning.
− Draft insufficient <10 Pa.
− Not correct regulation during
ignition operation
− The stove should be cleaned.
− Temperature of water in the
heating plant to low.
− Condensate drainage system
not available
− Exhaust chimney not
sufficiently insulated.
50/124
IT IT IT IT- - - - GB GB- - - - FR FR- - - - ES ES- - - - DE DE mod. 703T
GB GB FR FR ES ES DE DE
SOLUTION
− Require chimney sweep
intervention.
− Clean the stove.
− Use weathered and better quality
of wood.
− Call the assistance service/
chimney sweep.
− Verify the correct closure of the
doors and the seal of the gaskets
− Modify the flue : increase the
section, the height, verify the
isolation. Eliminate or reduce to
the minimum horizontal sections
and curve. Verify the section and
the height of the chimney cap
(see reflux zone)
− Require chimney sweep
intervention.
− See charter "Regulations" and
"Fuel to be utilized"
− Clean the stove
− Regulate the water temperature
> 55°C
− Require a chimney sweep
inspection of the chimney.