Olivetti d-Copia 300MF Guide De L'utilisateur page 143

Slit Glass
OPERATION GUIDE
Glass Surface
If black streaks or
dirt appears in
copies when using
the optional
document
processor, clean the
slit glass with the
supplied cleaning
cloth. The message
Clean the slit glass.
may be displayed if
the slit glass
requires cleaning.
IMPORTANT: Lightly wipe the slit glass with a dry cloth. To remove
adhesive material or ink, apply alcohol to a cloth and wipe lightly. Do not
use water, thinner, or organic solvents.
1
Remove the cloth from the cleaning cloth compartment.
2 Open the document processor
and wipe the slit glass (a).
3
Press [End].
Clean the slit glass.
1.Open the document processor.
2.Clean the surface of the slit glass located
3.Close the document processor
4.Lift the reverse unit and clean the slit
5.Set the reverse unit
6.Press [End].
Note that dirty glass and sheet may cause
black streaks to appear in the output.
03/14
Hold
Status
a
Maintenance
on the left side with the supplied dry cloth.
and open the document processor cover.
glass and the white sheet with a dry cloth.
and close the document processor cover.
End
10/5/2006 10:10
5-3