JANE Montecarlo R1 Mode D'emploi page 29

Place the child in the MONTECARLO R1 and make sure that he is
3f
sitting well back, pass the seat belt over him and fasten it.
Insert the shoulder belt into the red clip on the headrest (9)
3g
Pass the abdominal belt under both armrests of the booster seat,
the area where the belt should go is marked in red again (10).
3h
Lastly, tighten the seat belt.
To get the child out of the seat, simply unfasten the seat belt
When it is not in use, DO NOT leave the MONTECARLO R1 seat
loose in the vehicle, always secure it with the seat belt or store it
in the boot. When you place the child back in the seat again, make
sure that none of the straps are twisted or out of place.
IM-1388.06 MONTECARLO R1.indd 29
4 Reclining the seat:
To offer the child greater comfort the safety seat can be reclined. Max-
imum safety is achieved when the seat is not reclined.
Do not recline the seat while the child is using it. To recline or
straighten your MONTECARLO R1 safety seat, you should adjust
the length of the seat belt. Do this when the vehicle has stopped.
4a To recline the seat raise the front part of the booster seat and slide
it to the required position. It has 2 positions.
5 Adjusting the width of the sides of the backrest and headrest.
5a
To adjust the sides of the backrest and headrest turn the handles
found on the side of the seat (6 and 7). Turn the handles clockwise
to open the sides and anticlockwise to close them.
6 Adjusting the armrest.
6a
To adjust the armrest (4), press in the middle (5) and turn it to the
required position. It has 3 positions.
29
28/10/16 10:39