JANE Montecarlo R1 Mode D'emploi page 26

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
Pre-adjustments
1 Fitting the backrest onto the booster seat
MONTECARLO R1 has been designed as a booster seat with a backrest,
never use the two parts separately.
To fit the backrest onto the booster seat lift the upholstery on the
1a
back of the booster seat, hold the backrest in a horizontal position
and slot the two legs of the backrest into the holes in the booster
seat.
1b
Raise the backrest to its vertical position.
1c
Fit the locking part onto the back of the backrest legs, it only fits
properly in one position, and lastly, fasten it on with the 4 screws.
Store the key in the compartment of the locking part in case you
need to take it off in the future.
26
IM-1388.06 MONTECARLO R1.indd 26
2 Checking the height of the shoulder belt
To ensure maximum safety for the child, the shoulder belt should
pass slightly above the shoulder. This position will need to be ad-
justed as the child grows.
2a
Place the child in the seat, make sure he is positioned correctly. The
belt should go slightly above the child's shoulder.
2b
To adjust the height, pull the button found behind the headrest (8)
and slide the headrest in the required direction. When it is at the
correct height, release the button and move the headrest to the
nearest locking position, it should click into place.
!
WARNING. Check and adjust this position as the child grows.
28/10/16 10:39

Publicité

Table des Matières
loading

Table des Matières