Grundig DSB 980 Manuel D'utilisation page 40

MAIN OPERATION ____________________________
Scanning for stations
• The first time you select DAB radio mode, or if
the station list is empty, the radio automatically
performs a full scan to see what stations are
available. You may also need to start a scan
manually to update the list of stations.
• To start a scan manually, choose Full scan. To
scan only stations with good signal strength,
select Local scan. Once the scan is complete,
the radio shows a list of available stations.
• To remove stations that are listed but not
unavailable, choose Prune invalid. Turn the
navigate reel to view a list of stations and press
to select.
• Once selected, the station plays and the screen
show information about station, track or show
as broadcast.
• On the screen press [ , ] on the remote control
to wiew the station list.
Settings
• Dynamic range compression (DRC) If you are
listening to music with a high dynamic range in
a noisy environment, you may wish to compress
the audio dynamic range. This makes quiet
sounds louder, and loud sounds quieter. You can
change DRC as off, low or high.
• Station order You can choose the order of the
DAB station list to be either Alphanumeric,
Ensemble or Valid. Ensemble lists groups of
stations that are broadcast together on the
same ensemble. Valid lists valid stations first,
alphanumerically, then off-air stations.
40 ENGLISH
FM Radio
• FM radio mode receives analogue radio from
the FM and displays RDS (Radio Data System)
information about the station and where
broadcast.
• The first time you select FM radio mode, or if the
station list is empty, the device will run auto scan
and save the stations to the preset list.
• To find a station, press [ ] The frequency
display starts to run up as the device scans the
FM band. Alternatively, you can scan up or down
by turning the navigate knob.
Settings
• ATS: Run the auto scan function once
• Scan settings By default, FM scans stop at
any available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations.
To change the scan settings to stop only at
stations with good signal strength, select Yes
after choosing Strong station only.
• Audio settings All stereo stations are reproduced
in stereo. For weak stations, this may result in
a poor signal-to-noise ratio (hiss). To play weak
stations in mono, select FM weak reception:
Listen in mono only and then YES.