Safety Precautions - Tennant SunFlash Manuel Opérateur Et Piéces

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SAFETY PRECAUTIONS

The following symbols are used throughout this
manual as indicated in their description:
WARNING: To warn of hazards or
unsafe practices that could result in
severe personal injury or death.
CAUTION: To warn of unsafe practices
that could result in minor or moderate
personal injury.
FOR SAFETY: To identify actions that
must be followed for safe operation of
equipment.
This machine is designed solely for the purpose of
curing floors using the Eco--UVS floor coating.
Tennant does not recommend using this machine
with any other floor coating.
The following information signals potentially
dangerous conditions to the operator or
equipment. Read this manual carefully. Know
when these conditions can exist. Locate all safety
devices on the machine. Then, take necessary
steps to train machine operating personnel.
Report machine damage or faulty operation
immediately. Do not use the machine if it is not in
proper operating condition.
WARNING: Hazardous voltage. Do not
operate with damaged power cord. Do
not modify plug. Unplug power cord
before servicing machine.
CAUTION: Ultraviolet (UV) exposure
may cause eye damage. Do not operate
without coverings. Do not look into UV
source. Wear UV eye protection.
2
Home
SAFETY PRECAUTIONS
FOR SAFETY:
1. Do not operate machine:
- - Unless trained and authorized.
- - Unless operation manual is read and
- - Unless cord is properly grounded.
- - With damaged cord or plug.
2. Before operating machine:
- - Make sure all safety devices are in
3. When using machine:
- - Do not run machine over cord.
- - Do not pull machine by plug or cord.
- - Do not pull cord around sharp edges
- - Do not unplug by pulling on cord.
- - Do not stretch cord.
- - Do not handle plug with wet hands.
- - Keep cord away from heated surfaces.
- - Report machine damage or faulty
- - Never allow children to play on or
4. When servicing machine:
- - Unplug cord from wall outlet.
- - Use manufacturer supplied or
- - Allow bulbs to cool before replacing.
- - All repairs must be performed by a
- - Do not modify the machine from its
5. When transporting machine:
- - Get assistance when lifting machine.
- - Unplug cord from wall outlet.
- - Use tie- -down straps to secure
Find... Go To..
understood.
place and operate properly.
or corners.
operation immediately.
around.
approved replacement parts.
qualified service person.
original design.
machine to truck or trailer.
SunFlash 331130 (9- -04)

Publicité

Table des Matières
loading

Table des Matières