Commissioning; Troubleshooting - Modular 70/40 IND-T Installation-Emploi-Entretien

Fourneaux a induction
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
GAS
See Chapter " Instructions for installation ".
14.

COMMISSIONING

See Chapter " Instructions for installation ".
15.

TROUBLESHOOTING

FAULTY
CAUSE
Continuous
heating of
Unsuitable pans
cooking zone at
maximum power
Insufficient
Defective knob
heating of
parts
cooking zone
Cooking zone
operates without
Defective pot
pan. Small metal
detection sensor
items heat up
The appliance
Fuses blown or
does not switch
interruption of
on
power supply
The fuses blow
when the
Generator short-
appliance is
circuit
switched on
Pan diameter
smaller than
The cooking zone
12cm
does not heat
Defective
generator
IF THE RED AND GREEN INDICATOR ARE OFF:
- Check the fuses.
- Power supply main switch disconnected.
- Insuffi cient voltage or incorrect electric connection
IF THE RED AND GREEN INDICATOR ARE ON:
- Disconnect the inductor from the terminal board
- Remove the inductor, lifting it downwards.
- Replace the faulty component.
CORRECTIVE
MEASURE
ERROR
Use suitable
pans
E1 <-> 01
Check/replace
the part
E1 <-> 02
Replace the
generator
Check
connections
E1 <-> 03
Replace the
generator
Use suitable
pans
Replace the
generator
E1 <-> 04
22
of the appliance.
Check and count the green indicator light flashes.
Each long flash is followed by a certain number of
short flashes. This number is the code of the
malfunction message detailed in the following
table:
located on the generator.
MESSAGE
CAUSE
Unsuitable
pans,
High
wrong or
voltage
defective
inductor
Faulty
No power
inductor
at inductor
connectio
n
Air vents
blocked,
fan not
Generator
working,
overheatin
filter
g
clogged,
faulty
temperatu
re sensor
Empty
pan,
Cooking
defective
zone
temperatu
temperatu
re sensor
re too high
or too low
faulty
power
indicator
CORRECTIVE
MEASURE
Unsuitable pans,
wrong or
defective
inductor
Faulty inductor
connection
Air vents
blocked, fan not
working, filter
clogged, faulty
temperature
sensor
Remove the
cookware, turn
off. Let cool
down the area
before switch on
again.
Replace the
generator

Publicité

Table des Matières
loading

Table des Matières