Using The Induction Hob / Wok - Modular 70/40 IND-T Installation-Emploi-Entretien

Have the appliance serviced at least twice a year.
The manufacturer recommends taking out a service
contract.
The appliance is designed for professional use and
must be operated by trained personnel.
The appliance is to be used for cooking food as
specified in the prescriptions for use. Any other use
is considered to be improper.
Do not allow the appliance to operate empty for
prolonged periods. Only pre-heat the oven just
before use.
Do not leave the appliance unattended while in
operation.
In the event of an appliance fault or malfunction,
shut the gas shut-off valve and/or switch the
appliance off at the main switch installed upline.
Clean the appliance following the instructions given
in Chapter " INSTRUCTIONS FOR CLEANING".
DO NOT STORE " AMMABLE MATERIALS
IN CLOSE PROXIMITY TO THE
APPLIANCE. FIRE HAZARD.
Do not obstruct any air vents or drains present on
the appliance.
Do not tamper with appliance components.
Keep this manual in a safe place, known to all
users, so that it can be consulted throughout the
working life of the appliance.
Installation and appliance maintenance must be
carried out by qualified technicians authorized by
the manufacturer, in compliance with current
safety standards and the instructions in this
manual.
Appliance maintenance and conversion to a
different type of gas must be carried out by
qualified technicians authorized by the
manufacturer, in compliance with current safety
standards and the instructions in this manual.
9.

USING THE INDUCTION HOB / WOK

The appliance is designed for cooking foods
contained in pots and pans.
Use flat bottomed pans.
Do not leave the hotplates switched on with no
pan or an empty pan in place.
Do not pour cold liquids onto the hot hotplate.
The induction hob (made of glass ceramic) is ready
for use, no pre-heating is required.
Do not use multi-layered pots with aluminium core
open along the edge.
The induction heating system will not function with
unsuitable materials. These are : chrome-nickel
stainless steel, aluminium, copper, brass, glass,
stoneware.
Pots with a diameter smaller than approx. 12cm
are not detected by the system and the appliance
will therefore not switch on.
Use pots with a maximum diameter of 28cm for
maximum heating efficiency.
Do not leave the hotplates switched on with no
pan or an empty pan in place.
Take care when moving pots on the hob. Dropping
items on the glass ceramic hob may cause
irreparable damage.
Position pots in the centre of cooking zones.
Only use pots and pans specifi cally designed for
induction cookers and beware of those which are
very cheap.
SWITCHING ON AND OFF
The thermostat control knob has the following
positions:
OFF
MINIMUM TEMPERATURE
INTERMEDIATE TEMPERATURES
MAXIMUM WATER TEMPERATURE
SWITCHING ON
- Turn the thermostat knob to the chosen
temperature setting for cooking.
20