Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

1. Place the juice receptacle on the motor housing.
2. Place the grating cone on the driver, press it down lightly.
3. Put the lid on the juice receptacle.
4. Snap the closing clip shut.
NOTE: If the closing clip does not shap shut properly, the motor safety switch
cuts out.
5. Place the pulp container underneath the ejector in the lid.
6. Place the juice jug under the tap of the juice receptacle.
7. Plug in the mains plug.
8. Select the suitable speed.
9. Feed the fruit into the feed chamber and press lightly with the stuffer.
ATTENTION: Never stick your fingers or any objects into the feed chamber.
Always only use the stuffer.
10. The juice flows through the juice receptacle into the juice jug, the fruit pulp falls
through the ejector into the pulp container.
CAUTION: do not tip the tap up if there is still a large amount of juice in the drip
pan.
11. Pause for a minute after one minute of continuous operation.
ATTENTION: Remove the pulp which accumulates in the lid continuously (after
one minute of continuous operation) to prevent the motor from jamming.
12. Clean the juice maker as described in chapter 8.
6.2.

Mixing

You can use the mixer for mixing and for blending. It is ideal for processing soups,
sauces, milk shakes, baby food, vegetables, mashed fruit and purée.
1. Place the mixer attachment on the motor housing.
2. Fruit or vegetables must be peeled, stones removed and cut into small pieces before
filling.
3. Fill the vessel up to the MAX mark (about 1.8 litres) at the most.
ATTENTION: Do not fill liquids hotter than 80°C into the vessel. Do not run the
utensil empty.
4. Put the lid on the mixing vessel.
5. To fill ingredients whilst the mixer is running, you can remove the cap in the centre of
the lid. Replace the cap afterwards.
6. Plug in the mains plug.
7. Press the pulse button P 3 to 5 times.
8. Switch on the desired speed (speed 1 = slow, speed 2 = fast).
BEEM – Elements of Lifestyle
The tap must always be folded down while juicing (see Ill.),
to ensure that the juice does not run out and damage the
motor. You can tip the tap up to take advantage of the drip
stop only once you have finished juicing or if you wish to
empty or replace the drip pan, and only a little juice is still
dripping from the tap.
16/52

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kp60sc

Table des Matières