Broan Elite EI5936SS Manuel D'installation page 5

INSTALL THE HOOD (Non-Ducted Hoods Only - Steps 3 thru 8)
NON-DUCT KIT MODEL RKE59 CONTENTS
NON-DUCT PLENUM
4 MOUNTING
ASSEMBLY
SCREWS
(.188" x .375"
Cross Recessed
Flat Head)
FLEXIBLE DUCT
NON-DUCTED RECIRCULATION FILTERS
NOTE
Non-ducted installations require Non-Duct Kit, Model RKE59
(purchase separately).
3. Disassemble the frame by removing (8) screws. Set aside
screws and lower frame assembly.
4 MOUNTING
SCREWS
(3mm x 10mm
Cross Recessed
Pan Head)
4 FOAM
RECTANGLES
FILTER TRAY
4. Align upper frame assembly to ceiling framing, and attach
to ceiling framing with (6) 4mm x 50mm screws. Tighten
securely, making sure that the upper frame bracket is tight
against the ceiling.
F R O
5. Install non-duct plenum to upper frame bracket using (4)
3mm x 10mm screws.
6. Feed house wiring around front of non-duct plenum.
F R O N T
7. Determine length "L" of frame assembly based upon desired
installation height. See chart on page 4. Slide lower frame
over upper frame and attach with (8) screws previously set
aside.
MODEL EI5936SS
CEILING
MATERIAL
IS INSTALLED.
CEILING
FRAMING
ABOVE -
F R O N T
SHOWN
AS DOTTED
LINES.
N T
LENGTH
"L"
Page 5