Troubleshooting - Ergomotion Serta Motion Perfect Manuel Du Propriétaire

troubleshooting

•
Check under the bed base to verify that the wired connections are secure and that there are no cords or bedding obstructing the
movement of the base .
•
Check to ensure the green LED light is illuminated on the control box . If there is no light, verify that the input and power cords are
properly connected .
•
Unplug the base for 1 hour to reset the electronic components .
•
Plug bed base into a different electrical outlet, or test current outlet with another working appliance (a grounded, electrical surge
protector is recommended) .
•
Remove and replace full batteries in the remote control and re-pair the remote to the base (see page 13) .
If issue is not resolved by following the instructions above, locate serial number on warranty card or back of remote and call
18
Ergomotion Customer Service: (888) 550-3746