GBC SwingLine Série Manuel D'utilisation page 5

How to bind
Measure document using colour coded guide
1
(fig.1)
Select Click spine which fits your document (fig.2)
2
Use the table to choose a suitable Click spine size.
Please note that this guide is based on 80gsm paper.
Load Click onto machine (fig.3)
3
Fully open the selected Click spine and secure it
under the hooks in the binding channel at the front of
the machine, with the open rings of the spine facing
upwards.
Select document size (fig.4)
4
Rotate the edge guide to the paper / cover size you
wish to bind; A4 (297mm x 210mm) or Letter (215mm x
279mm). When using oversized covers, rotate the edge
guide to the oversize position, punch the covers for your
document and set aside. Then rotate the edge guide to
select either A4 or Letter and proceed.
Load pages into slot (fig.5)
5
You can punch 2 cover sheets (0.2mm) or up to 15
sheets of paper (80gsm) at a time. Select the quantity
of sheets to punch and tap the edge of the sheet stack
against a flat surface to ensure that all sheets are
aligned. Push the side of the stack to be punched into
the punching slot as far as it will go, and slide left to
align with the edge guide. When properly aligned, both
of the two red flags visible on the top cover of the binder
will turn green.
Maintenance
Please ensure that the
clippings tray is emptied on a
regular basis. This will prevent
blockage and ensure that the
unit is always ready to punch.
The clippings tray can be
accessed from the back of the
machine.
In order to prevent overloading never try and punch more
than the maximum numbers of sheets recommended (15
sheets of 80gsm). The unit is maintenance free if handled
correctly.
Punch pages (fig.6)
6
ProClick P110 (Manual Punch)
Punch pages by pulling handle down.
Then lift the handle back to the vertical position and
remove the punched sheets.
ProClick P210E (Electric Punch)
Press the ON / OFF button
to indicate that the power is on. And the punch button
will light up in green.
To punch, press the illuminated green punch button
When finished punching turn the machine OFF by
pressing the ON / OFF
If the punch jams the red jam light
indicate that the machine has jammed. The machine
will automatically reverse the punches to clear the jam
and the red jam light will remain illuminated. Remove the
paper and push the punch button to re-set the machine.
The red jam light will turn off indicating that the machine
is ready to punch. Reduce some of the sheets and
repeat steps 2 to 4 to avoid jams on additional lifts.
Note: If the red light remains on, unplug the unit and
contact an authorised Swingline
representative for any required repairs.
When finished punching turn the machine OFF by
pressing the ON / OFF
Combine pages with Click (fig.7)
7
Remove the sheets from the punch slot and insert on to
the fingers of the Click.
Repeat process as required
8
Repeat stages 5-7 until your document is fully loaded
on the Click spine.
Close the Click spine (fig.8)
9
Close the Click spine by firmly snapping the open Click
spine fingers together with your hands, or alternatively
the ClickBind closing tool (fig.8a).
Service
Contact an authorised Swingline
representative for any required repairs.
o
US
. A blue light will illuminate
button.
will illuminate to
GBC service
™ ®
button.
GBC service
™ ®
.
5