GRAUPNER 4197 Notice D'utilisation page 6

All manuals and user guides at all-guides.com
PS 5,9V
Technical features / function Technical features / function
Input voltage:
Output voltage:
Current capacity (<75°C):
The stated values apply if the PS is operated without active cooling, i.e. (typically) by the
airflow. If forced cooling is used the values are even higher.
CAUTION: AT HIGH CURRENTS THE UNIT WILL BECOME HOT!
- The PS is looped in between the receiver and the servo, and supplies a safe 5.9 V to
your servo.
- The purpose of the PS is to allow the use of conventional servos, for which the
recommended operating voltage limit is around 6 V, with a receiving system which is
connected directly to a battery such as a 2S LiPo pack.
- When using the PS it is important to check the current drain of the servos, in order to
avoid overloading the PS.
- The following illustration shows a typical wiring arrangement for the PS, the receiver - The following illustration shows a typical wiring arrangement for the PS, the receiver
and a servo.
approx. 1.2 V to 1.2 V to
1.2 V 8.5 V
approx. 5.9 V (if the input voltage is less than 5.9 V, the 5.9 V 5.9 V (if the input voltage is less than 5.9 V, the
output voltage is the same as the input voltage)
8 A (for approx. 5 sec. at 7.4 V)
2.5A 2.5A 2.5A (for approx. 100 sec. at 7.4 V) (for approx. 100 sec. at 7.4 V)
(for approx. 150 sec. at 7.4 V) (for approx. 150 sec. at 7.4 V)
1.5A 1.5A 1.5A
6