Tripp-Lite SmartPro Serie Manuel De L'utilisateur page 9

Specifications
Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice.
SmartPro ® UPS Systems
Model Number:
Series Number:
Input Voltage/Frequency:
On-Line Input Voltage Range:
Output Capacity (VA/Watts):
Battery Runtime
(Half Load/Full Load) Minutes:
Battery Recharge Time:
Approvals:
SmartPro ® XL UPS Systems
Model Number:
Series Number:
Input Voltage/Frequency:
On-Line Input Voltage Range:
Output Capacity (VA/Watts):
Battery Runtime
(Half Load/Full Load) Minutes:
Battery Recharge Time:
Approvals:
ALL UNITS:
Output Waveform Line Mode (filtered sinewave); Output Waveform Battery Mode (PWM sine wave); AC Surge Suppression
(exceeds IEEE 587 Cat. A & B standards); AC Noise Attenuation (>40 dB at 1MHz); AC Protection Modes (H to N, H to G, N to G).
+ Battery runtime can be extended with addition of optional Tripp Lite External Battery Packs (Model #: BP36V27, sold separate-
ly). External batteries will increase both the battery runtime and the battery recharge time.
FCC RADIO/TV INTERFERENCE NOTICE (U.S. ONLY):
This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause unde-
sired operation.
FCC CLASS A RADIO/TV INTERFERENCE NOTICE (U.S. ONLY):
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when operated in a com-
mercial environment. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in
accordance with the instruction manual, may cause interference to radio communications. Operation of this equipment is likely to
cause harmful interference in which case the user will be required to correct the interference at his own expense. The user must
use shielded cables and connectors with this product. Any changes or modifications to this product not expressly approved by the
party responsible for compliance could void the user's authority to operate the equipment.
FCC CLASS B RADIO/TV INTERFERENCE NOTICE (U.S. ONLY):
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the
instruction manual, may cause interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference using one or more of the
following measures: reorient or relocate the receiving antenna; increase the separation between the equipment and the receiver;
connect the equipment into an outlet on a circuit different from that which the receiver is connected; consult the dealer or an expe-
rienced radio/television technician for help. The user must use shielded cables and connectors with this product. Any changes or
modifications to this product not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
Note on Labeling
Two symbols are used on the label.
V~ : AC Voltage
V : DC Voltage
SMART700
AGSM700PJR3
120V/60 Hz
79 - 147 volts
700/450
20/6
2-4 hrs.
UL, cUL, NOM, FCC B
SMART750XL
AGSM1500XPSR3
120V/60 Hz
79 - 147 volts
750/600
29/12+
2 - 4 hrs.
UL, cUL, NOM, FCC A
SMART1050
AGSM1050PJR3
120V/60 Hz
79 - 147 volts
1050/705
23/8
2-4 hrs.
UL, cUL, NOM, FCC B
SMART1050XL
AGSM1500XPSR3
120V/60 Hz
79 - 147 volts
1050/800
19/8+
2 - 4 hrs.
UL, cUL, NOM, FCC A
9
SMART1500
AGSM1500XPSR3
120V/60 Hz
79 - 147 volts
1500/980
20/7
2-4 hrs.
UL, cUL, NOM, FCC A
SMART1500XL
AGSM1500XPSR3
120V/60 Hz
79 - 147 volts
1500/980
20/7+
2 - 4 hrs.
UL, cUL, NOM, FCC A