Tripp-Lite SmartPro Serie Manuel De L'utilisateur page 7

Basic Operation
Other UPS Features
USB port
RS-232 (DB9 port)
NORM DELAY
continued
www.tripplite.com/support/battery/index.cfm to locate the specific
Tripp Lite replacement battery for your UPS.
AC Receptacles: These output receptacles provide your connected
equipment with AC line power during normal operation and battery
power during power outages. The UPS protects equipment connected
to these receptacles against damaging surges and line noise. If you
have a USB or DB9 connection to your UPS, you can remotely reboot
connected equipment by turning its receptacles OFF and ON using
Tripp Lite software. Select models have a receptacle or receptacles
(clearly identified on the rear panel) that may be remotely switched
ON and OFF without interrupting power to other outlets. See soft-
ware instructions for details.
Communication Ports (USB or RS-232) (Select Models Only):
These ports connect your UPS to any workstation or server. Use with
Tripp Lite's PowerAlert Software and included cables to enable your
computer to automatically save open files and shut down equipment
during a blackout. Also use PowerAlert Software to monitor a wide
variety of AC line power and UPS operating conditions. Consult your
PowerAlert Software manual or contact Tripp Lite Customer Support
for more information. See "USB Communications" and "RS-232 Serial
Communications" in the "Optional Installation" section for installation
instructions.
Battery Replacement Door: Under normal conditions, the original
battery in your UPS will last several years. Refer to "Battery
Warnings" in the Safety section on page 2.
Input Breaker: Protects your electrical circuit from overcurrent
draw from the UPS load. If this breaker trips, remove some of the
load, then reset it by pressing the breaker in.
External Battery Connector (Select Models Only): Use to connect
one or more Tripp Lite battery packs for additional runtime. Refer to
Specifications and/or the label next to the connector to determine the
appropriate variety of battery pack to use. Refer to the battery pack
instruction manual for complete installation information and impor-
tant safety warnings. See "External Battery Connection" in the
"Optional Installation" section.
Battery Charge Level Switch (Select Models Only): Select models
feature a switch that controls the UPS system's battery charge rate. If
you connect more than one external battery, set the Battery Charge
Level Switch to the right. This will increase your UPS's charger out-
put so the additional batteries charge faster.
CAUTION! DO NOT set the Battery Charge Level Switch to the right
without an external battery connected. There is a risk of damaging the
UPS's internal battery system.
Power Sensitivity Adjustment (Select Models Only): This dial is nor-
mally set fully counterclockwise, which enables the UPS to protect
against waveform distortions in its AC input. When such distortion
7