Battery Status; How To Switch Off The Transmitter - Beyerdynamic S 910 Mode D'emploi

3. LC-Display
1. "ERR" Message: When the "ERR" message is displayed, there is an error.
ERR noo3: The frequency you want to program is above the switching
bandwidth of the transmitter. Use a receiver with an appropriate
frequency group. (At this time the microphone is still operating and the
frequency remains unchanged. To clear the displayed "ERR" message
switch off the handheld transmitter and on again.)
ERR noo4: The frequency you want to program is below the switching
bandwidth of the transmitter. Use a receiver with an appropriate
frequency group. (At this time the microphone is still operating and the
frequency remains unchanged. To clear the displayed "ERR" message
switch off the handheld transmitter and on again.)
2. "Group" & "Channel": When both indications are displayed, it means
that you are using the pre-programmed frequency of the receiver.
3. "Channel": If "Channel" is displayed only, it means that you are using a
frequency which is not pre-programmed.
4.

Battery status

• When the battery is exhausted, "0%" is displayed. When "PoFF" is
displayed, the transmitter is switched off, to avoid over-discharging the
battery.
Furthermore, the "Batt Low" LED of the TS 910 C beltpack transmitter will
illuminate.
Replace or recharge the battery.
5.

How to switch off the transmitter

When the ON/OFF switch is switched to "OFF", at first "PoFF" is displayed
and as soon as the transmitter is completey off the display is blank. Wait one
second if you want to switch on the transmitter again immediately.
41