Amibot EVERYBOT Swip AS50 Manuel D'utilisation page 20

EN
Troubleshooting
The robot does not
02
move correctly
The appliance
03 has lost cleaning
efficiency.
The remote
04 control does not
work.
If none of the above-mentioned steps provide a solution for your
problem, please contact the AMIBOT after-sales department.
1. The floor is too wet.
2. The water tanks
are not attached
correctly.
3. The cleaning pads
are too damp.
4. The floor is on a
slope of more than
10%.
5. The gap and
obstacle sensors
are dirty.
1. The cleaning pads
are dirty.
2. The water tanks are
empty.
3. The robot battery is
weak.
1. The batteries
are not inserted
or need to be
replaced.
2. The remote control
is broken.
18
1. Dry the floor.
2. Remove and reinsert
the water tanks.
3. Remove and wring
out the cleaning pads
before reattaching
them to the water
tanks.
4. Place the robot on a
flat surface that is no
more than 10%.
5. Clean the sensors
using a soft cloth.
1. Replace the cleaning
pads.
2. Refill the water tanks
with clean water
and your usual floor
cleaner.
3. Charge the robot.
1. Change the batteries.
2. Replace the remote
control with a new
one.