H.Koenig BW1778 Manuel D'utilisation page 6

2. Install the tap handle connect the tap, make sure both end fit together perfectly. (Show as
Figure 4)
3. Set the water drip tray into the notch provided. (Show as figure 5)
4. Open the beer cooler with 60-80N strength.
Note: Do not connect or disconnect the electric plug when your hands are wet. Before use it,
make sure the voltage is conformity with plug mark, and check whether the power cord is
well connected or not; if not, please don't use it, and call service center;
5. Put 800ml water into the cooling cavity or pour the water to the max mark (Show as figure
6) (It can work without water, but it can't display the best performance)
Note: Make sure the drain switch is at "Off" position, and no extra objects in the cooling
cavity.
The max water
level line (800ml)
6. Place the well-assembled keg into the cooling cavity; Connect the CO2 connector tube and
beer outlet tube with the keg lifter tube connector.
NOTES: make sure all connection of tap mechanism is well connected, and without damage.
And make sure tap valve is on close status, and the CO2 pressure regulator knob is at "Off"
status.
7. Plug the beer cooler.
Note: Do not connect or disconnect the electric plug when your hands are wet. Before use it,
make sure the voltage is conformity with plug mark, and check whether the power cord is
well connected or not; if not, please don't use it, and call service center.
8. Close the top cover of the beer cooler.
Figure 6
Make sure the drain
switch is at "OFF"
position.
Figure 7