H.Koenig BW1778 Manuel D'utilisation page 12

Note: Don't move other screws when processing tube replacement, otherwise, it may cause
the beer leakage or gas leakage.
Figure 16
MAINTENANCE
If the beer cooler does not work properly, please call the service center;
To save time and money, before you call for service, check the Troubleshooting Guide. It lists
cause of minor operation problems that you can correct yourself.
Trouble
The tap does not
work / can't pour
beer out
Too much bubble
pouring out
Beer flows out too
slowly
ENVIRONMENT
CAUTION:
Do not dispose of this product as it has with other household products. There is a
separation of this waste product into communities, you will need to inform your local
authorities about the places where you can return this product. In fact, electrical and
electronic products contain hazardous substances that have harmful effects on the
environment or human health and should be recycled. The symbol here indicates that
electrical and electronic equipment should be chosen carefully, a wheeled waste container
is marked with a cross.
Adeva SAS / H.Koenig Europe - 8 rue Marc Seguin - 77290 Mitry Mory – France
www.hkoenig.com - sav@hkoenig.com - contact@hkoenig.com - Tél: +33 1 64 67 00 05
1. Lock setting
Cause
1. The beer tube is in poor
connection
2. No keg or no beer in the keg;
1. Use a wrong way to pour beer
out
2. The beer temp is high (best at 3-
6℃)
3. The keg is shaken before usage
4. Almost no beer in the keg
The connection tube or beer tube
has leakage
2. Connector nut
Troubleshooting
1. Well connect the pouring
tube
2. Change a new keg
1. Use the right way to pour
beer out
2. Cool the beer down to 3-6℃
3. Put the beer keg aside a
while till no bubble inside
4. Change a new keg
Check whether the tube is
leakage or not, if so replace
the tube