Remote Start - LG LSWS309BD Manuel Du Propriétaire

REMOTE START

If the appliance is registered on a home Wi-Fi network, this
function starts preheating and then holds the temperature
for up to an hour (including preheating time). If the
appliance is not registered on the network, "unavailable"
appears in the display. Follow the instructions on page 28
to register the appliance on the network.
Setting Remote Start
1. Open the oven door to make sure the oven is empty
and ready for pre-heating. Close the oven door.
2. Within 30 seconds of closing the door, turn the oven
mode knob to select Remote Start.
If more than 30 seconds passes before you initiate
Remote Start, a warning message will begin to scroll
across the display and Remote Start will not initiate.
If this occurs, open and close the oven door and try
again.
3. When "Remote Start Ready" appears in the display,
the Remote start function is ready to use.
4. Follow the directions in the smart phone application
to set the cook mode, temperature, and run time
(preheating time plus holding time).
NOTE
Do not place food in oven before or during Remote
Start run time.
Remote Start is disconnected in the following
situations:
• Remote Start is never set up in the smart phone
app.
• The Remote Start status is "unavailable" or "AFTER
OPENING AND CLOSING THE DOOR, PLACE THE
MODE DIAL BACK TO REMOTE START WITHIN 30
SEC".
• Remote Start function can not be started when
either upper or lower oven is in use.
• The Remote Start function cannot be started when
the oven door is open. A beep alerts you to shut
the door.
27
USINg thE OVEN