By pressing the "Batt Type/Stop" button repeatedly the main menu will scroll through the differ-
ent charge program options and the user settings option.
To select an option from the main menu press the "Start/Enter" button.
Please consult the end of this manual for a program chart with all the different options of the
Charger.
LITHIUM POLYMER CHARGE PROGRAMS
Important!
voltage of 3.7V/cell. Do not try to charge any other type of battery using this program.
Individual Cell Connection Diagram shows the correct way to connect your battery to the
I-POWER charger while charging in the balance charge program mode only.
Warning
Failure to connect as shown in Individual Cell Connection Diagram will damage this charger.
This balance charging function is designed for JST-XH balance leads only. Do not try and fit any
other type of balance lead directly into this chargers balance ports. (If you are not sure what type
of lead you have then check with your local model shop before connecting to the balance ports
on this charger.)
The main battery leads must be connected along with the balance lead connector before charg-
ing your battery.
Individual Cell Connection Diagram (pin-assignment of 8-pin)
+
Individual
bal.port
WARNING: If using crock clips make sure they are unable to touch!
Lithium LiLo/LiPo/LiFe program
voltage of 3.3/3.6/3.7V/cell.
Different batteries have different charge technique. There are two methods termed as constant
voltage and constant current. The charge current varies according to battery capacity and
specification. The final voltage is very important; it should precisely match the voltage of the bat-
tery: LiPo is 3.6V, LiLo is 4.1V and LiFe is 3.6V. The current and voltage of the battery should be
correctly set.
1. Select this charge process by choosing LiPo CHARGE from the main menu by pressing the
"Start/Enter" button. The display should look similar to this:
LiPo 1S
+
LiPo 2S
Top View
+
-
LiPo 3S
+
LiPo 4S
+
LiPo 5S
+
LiPo 6S
+
+
www.rcplus.eu
1S
Top View
-
+
2S
+
+
Individual
bal.port
3S
+
+
9