Fast Charging Of Lithium Battery - RC-Plus I-POWER 680 Manuel D'instructions

2. The value on the left side of the second lines sets the charge current. The value on the right
side of the second lines sets the battery pack's voltage. After setting current and voltage,
press "Start/Enter" for more than 3 seconds to start the process.
3. This displays the number of cells you set up and the processor detects. `
Top Line: S = Number of cells selected by you in the previous screen.
R = Number of cells detected by the charger.
If both numbers are identical you can start charging by press "Start/Enter" button. If not, press
"Batt type/Stop" button to go back to previous screen to carefully check the number of cells of
the battery pack before going ahead.
4. This screen shows the real-time status during charge process. Press "Batt type/Stop" key
once to stop the charge process.
Number of cells Charging current

Fast charging of Lithium battery

Charging current will normally be reduced during the final stage of the charging process. This
specific CV process will increase the final charging current to end the charging process earlier.
The total charged capacity during fast charging will be a little less than during normal charging,
but charging time will be shortened accordingly.
1. Select this charge process by choosing LiPo FAST CHARGE from the main menu by pressing
the "Start/Enter" button. The display should look similar to this:
You can set up the charging current and voltage of the battery pack. Press "Start/Enter" key to
display voltage confirmation.
2. Then press "Start/Enter" key again to confirm and begin to charge. This screen shows the real-
time status of "fast charging". Press "Batt type/Stop" key once to stop the charge process.
Battery voltage
Charging time Supplied capacity
www.rcplus.eu
11