Introduction; Specifications; Special Features - RC-Plus I-POWER 680 Manuel D'instructions

INTRODUCTION

Thank you for purchasing the new I-POWER Charger. This product is a rapid charger with a high
performance microprocessor and specialized operating software. Please read this entire operat-
ing manual completely and attentively before using this product, as it covers a wide range of
information on operating and safety.
Specifications
Operating voltage range:
Charge Max.:
Discharge Max.
Charge current.:
Discharge current:
Current balancing Li-Po: 250mAh/élmt
Nb of Nixx cells:
Nb of Li-xx cells:
Nb of PB cells

Special features

Optimal operating software
I-POWER features the so-called AUTO function that set the feeding current during the process
of charging or discharging. Especially for Lithium batteries, it can prevent the overcharging which
may lead to an explosion due to the user's fault. It can disconnect the circuit automatically and
alarm once detecting any malfunction. All the programs of this product were controlled through
two way linkage and communication, to achieve the maximum safety and minimize the trouble.
All the settings can be configured by users!
Internal independent lithium battery balancer
I-POWER employs an individual-cell-voltage balancer. It isn't necessary to connect an external
balancer for balance charging.
Balancing individual cells battery discharging
During the process of discharging, I-POWER can monitor and balance each cell of the battery
individually. Error message will be indicated and the process will be ended automatically if the
voltage of any single one cell is abnormal.
Adaptable to various type of lithium battery
I-POWER is adaptable to various types of Lithium batteries, such as Li-ion, LiPo and the new
LiFe series of batteries.
Fast and storage mode of lithium battery
Purposes to charge Lithium battery varies, 'fast' charge reduce the duration of charging, whereas
'store' state can control the final voltage of your battery, so as to store for a long time and protect
useful time of the battery.
Maximum safety
Delta-peak sensitivity: The automatic charge termination program based on the principle of the
Automatic charging current limit: You can set up the upper limit of the charging current when
4
I-POWER 680 I-POWER 6200
DC 11-18V DC 11-18V
80W 200W
10W 25W
0.1 - 6.0A 0.1 - 10A
0.1 - 2.0A 0.1 - 5.0A
300mAh/élmt
1-15 1-18
1-6 1-6
1-10 1-12
Delta-peak voltage detection. When the battery's voltage exceeds the
threshold, the process will be terminated automatically.
charging your NiCd or NiMH battery; it is useful for the NiMH battery of
low impedance and capacity in the 'AUTO' charging mode.
www.rcplus.eu
I-POWER 8150 I-POWER 4650
DC 11-18V DC 11-18V
150W 50W
25W 5W
0.1 - 7.0A 0.1 - 5.0A
0.1 - 5.0A 0.1 - 2.0A
300mAh/élmt 250mAh/élmt
1-18 1-15
1-8 1-6
1-18 1-10