Axis D2050-VE Guide D'installation page 17

Masquer les pouces Voir aussi pour D2050-VE:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
NO TICE
TICE
NO
NO
TICE
• If more than one cable is used, each cable must be routed through a separate cable gasket.
• Only open a hole in cable gaskets that will be used and if a cable gasket is torn, replace it
with a new cable gasket. Leaving a cable gasket open or using a torn cable gasket could
cause water to seep in and damage the product.
9. Push the network cable through the cable gasket.
NO TICE
TICE
NO
NO
TICE
If the network cable has a premounted network connector, remove the cable gasket and
use the connector guard to prevent tearing of the cable gasket. Avoid using network
cables with capped network connectors because they could cause tearing of the cable
gasket despite using the connector guard.
10. Pull the network cable back slightly so that the cable gasket adjusts itself on the cable.
NO
NO TICE
NO
TICE
TICE
Not pulling the cable back could cause water to seep in and damage the product.
11. Put back the cable gasket.
12. If connecting an auxiliary device, for example an I/O, repeat the step above as applicable
to the specific device.
NO
NO TICE
NO
TICE
TICE
Mount the connectors after the cables are pushed through the cable gasket.
13. To use a cable gland with strain relief, assemble it as shown below. Tighten the nut
and cap firmly by hand.
AXIS D2050-VE Network Radar Detector
17

Publicité

Table des Matières
loading

Table des Matières