How To Install The Product - Axis D2050-VE Guide D'installation

How to install the product

WARNING
Risk of electric shock. The product shall be grounded either through a shielded network
cable (STP) or using a grounding wire. If using a grounding wire, make sure both ends of
the grounding wire are in contact with their respective grounding surfaces.
CAUTION
Make sure that the screws and plugs are appropriate for the material (e.g. wood, metal,
drywall, stone) and that the material is strong enough to support the weight of the detector.
1. Use the drill template and mark the holes before drilling.
2. Fasten the mounting bracket to the wall.
3. Route the network cable through the mounting bracket. Leave approximately
30 cm (12 in) of cable for connecting the detector.
4. If connecting an auxiliary device, for example an I/O, repeat the step above as applicable
to the specific device.
5. Remove the front cover from the detector.
6. If using a microSD card for local storage, insert the card into the detector's microSD
card slot.
7. Attach the detector to the mounting bracket with the hooks and fasten with the screws.
AXIS D2050-VE Network Radar Detector
15