Changing Blades; Fixing Problems; Warranty - Wolf Garten SDE 2500 EVO Notice D'instruction D'origine

Changing blades

E
1
Remove the mains plug before any maintenance and
cleaning work!
When servicing the cutting tool ensure that it can still al-
ways run on even when the motor is switched off.
For safety reasons, always have the blades changed by an
authorised service centre.
1. Unscrew the knob and fold the casing upwards to open
2. In order to change the blades insert the hexagon spanner
in the slot on the retaining plate and through the cover.
3. Loosen the two screws with the Allen spanner
out the worn blades.
4. Insert the new blades and tighten the screws.
1
Remove both the Allen and hexagon spanner after com-
pleting the change.
5. Close the casing again and tighten the knob

Fixing problems

Problem
Motor does not start.
Motor hums but does not start
Motor does not start.
Reduced cutting output
When in doubt, always seek out a WOLF Service location.
Attention: Put down the appliance and pull out the power plug before performing any checks or work on the blades.

Warranty

The warranty rules issued by our company or the importer apply to every
country. As part of the warranty, we remedy malfunctions on your appli-
ance free of charge provided that this malfunction is caused by a material
or manufacturing defect. In the event of a warranty claim, please turn to
your dealer or the nearest branch office.
en
F
F
(2) and take
E
.
Possible cause
z Not connected to voltage supply
z Faulty connection cable
z Top of casing not closed properly (safety shutdown de-
vice is tripped)
z Blade unit blocked
z Faulty capacitor
z Extension cable too long or cross section too small
z Socket too far from main connection and connecting
lead cross section too small
z Dull blade.
Empty the collection container
1
Remove the mains plug before any maintenance and
cleaning work!
3
Note
The locking lever has the function of a safety switch and must
be in Position
lever should not be correctly snapped in, this and the switch
E .
must be cleaned in the product, if required.
F
(1)
1. Bring the locking mechanism to position 1.
2. Pull the collection container completely out of the frame.
3. Empty the container.
4. Slide the collection container onto the frame as far as it will go.
5. Bring the locking mechanism to position 2.
G
G
(2) while operating the product. If the locking
Solution
z Check protection
z Check the cable (electrical expert)
z Close top of casing properly and screw, re-
move dirt if required.
z Switch off appliance, remove mains plug
and clean appliance on the inside
z Give appliance to authorised WOLF-Gar-
ten customer service centre for repair.
z Extension cable min. 1.5 mm², max. 25 m
long. In the case of longer cable cross sec-
2
tion min. 2.5 mm .
z Changing blades
13