Fig. 7; Open The Clamping Lever (Fig. 5). Fig - Bosch PR10E Consignes De Fonctionnement/Sécurité

BM 2609140484 02-07
INSTALLING THE MOTOR INTO BASE
1. Open the clamping lever (Fig. 7).
2. Align the double triangles on the base and
motor then insert motor into base until it
stops (Fig. 7).

FIG. 7

2
3. Turn motor clockwise until single triangle
lines up with "unlocked" symbol. (Make
sure that the indication the base is aligned
with the line under the "unlocked" symbol
on the motor. Otherwise, the router can be
damaged.) (Fig. 8)
4. Move motor into base until the approximate
desired depth has been reached. (Fig. 8)
FIG. 8
3
5. Turn motor clockwise about 1/4" until single
triangle lines up with "locked" symbol. (Fig. 9)
6. Close the clamping lever. Always make
sure the motor sits tightly in the base. (The
2/28/07 9:38 AM
1
4
Page 9
tension of the clamping lever can be
changed by re-adjusting the nut.) (Fig. 9)
FIG. 9
5
6
CHECK SUBBASE LOCATION
Make sure that the bit and its cutter are
centered in the subbase opening. If necessary,
adjust the location of the subbase as follows:
1. Loosen the four screws that hold the subbase.
2. Adjust the location of the subbase as
needed so that the bit and its cutter are
centered in the subbase opening.
3. Tighten the four screws that hold the
subbase (Fig. 10).
Cutter diameter must be at
!
WARNING
least 1/4" smaller than
opening for the bit and cutter.
When the subbase has been centered in this
manner, the left and right edges of the
subbase are equidistant from the cutter, and
either side of the subbase can be used as a
guiding surface without worrying about a
difference in the cut line. See "Guiding The
Router" on page 12.
Note: This subbase is not designed for use
with templet guides. See optional PR009 and
PR010 Accessories for use of templet guides
with the palm router.
FIG. 10
-9-