Table Des Matières - Bosch PR10E Consignes De Fonctionnement/Sécurité

BM 2609140484 02-07
COLLET CHUCK CARE
With the router bit removed, continue to turn
the collet chuck counter-clockwise until it is
free of the shaft. To assure a firm grip,
occasionally blow out the collet chuck with
compressed air, and clean the taper in the
armature assembly shaft with a tissue or fine
brush. The collet chuck is made up of two
component parts that snap together (Fig. 4);
check to see that the collet is properly seated
in the collet chuck nut and lightly thread the
collet chuck back onto the armature shaft.
Replace worn or damaged collet chucks
immediately.
REMOVING MOTOR FROM BASE
1. Open the clamping lever (Fig. 5).
2. Turn the motor so that the single triangle
on the base lines up with "unlocked"
symbol on the motor. (Make sure that the
indication the base is aligned with the line
under the "unlocked" symbol on the motor.
Otherwise, the router can be damaged.)
(Fig. 5)
3. Pull the motor away from base until it stops
(Fig. 5).
4. Turn motor counterclockwise until it stops
(Fig. 6).
5. Pull motor out of base (Fig. 6).
2/28/07 9:38 AM Page 8
FIG. 4
Collet
Nut
FIG. 5
2
1
4
FIG. 6
-8-
Collet
Chuck
3
5
1