Unpacking; Assembly - Pinnacle International HEAT-STREAM HS-45-KFA Manuel De L'utilisateur Et Instructions D'utilisation

NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING OR WHILE CONNECTED
TO A POWER SOURCE

Unpacking

Remove the heater and all of the packaging materials from the
shipping carton.
NOTE: Save the box and packaging materials for future storage.

Assembly

Wheel support frame
Wheel (2 pieces)
Front and Rear Handle
Axle
Top Handle
Screws & Nuts (A) 8 each
Screws & Nuts (B) 4 each
Cotter Pins, Bushings, Washers (L & S)
Cord Wrap
Handle
Cord Wraps
Screws and
Nuts(4 ea.)
Hardware Kit Part#
70-056-0100
(HS-45 / 70T-KFA)
Front Handle
HS-45-KFA
NO
NO
NO
NO
YES
NO
YES
NO
YES
Wheels
Wheel Caps
Figure 4. Hardware Components
Wheel Support Frame
Figure 5. Frame components, Models HS-125T/175T/215T-KFA
Pinnacle Products International, Inc. Kerosene User's Manual
Check the chart below to be sure that you have all of the parts
required to assembly your heater. If you find that any parts are
missing, call 215-891-8460 for assistance in receiving the miss-
ing components.
HS-70T-KFA HS-125T-KFA HS-175T-KFA
NO YES
NO YES
NO YES
NO YES
YES NO
NO YES
YES NO
NO YES
YES YES
Frame Component Hardware
Washers,
(L) and (S)
Bushings
Kerosene
Forced Air Heaters
HS-215T-KFA
YES
YES
YES
YES
NO
YES
NO
YES
YES
Cotter Pins, Screws and Nuts (4
ea.) and Cord Wraps
Hardware Kit Part#:
70-056-0200
(HS-125T/ 175T / 215T-KFA)
Rear Handle
Axle
YES
YES
YES
YES
NO
YES
NO
YES
YES
Page 5