Initial Operation - Perry Electric 1IO6081 Mode D'emploi

5 - INITIAL OPERATION

Important: the following meanings are adopted in
the instructions.
A) First time switching on the device
When powered for the first time, some segments on the time display will be off. To activate them, lightly press the
thin object. After having performed the test cycle, the device will be ready for
Day
1 2 3 4 5 6 7
B) Switching on the device subsequent to the first time
The time switch presents itself in normal operation (backlit display with segments on). If you wish to fully program it, simulta-
neously press OK and PROG
for current hour entry.
Ok
Delete
Prog
Keep pressed
1 2 3 4 5 6 7
for 3 sec.
Ok
Delete
1 Prog
1 2 3 4 5 6 7
and keep pressed for 3 seconds
1 2 3 4 5 6 7 1 2 3 4 5 6 7
Characters
permanently
alight:
current hour entry.
1 2 3 4 5 6 7
. After having performed the test cycle, the device will be ready
Re-start can always be performed by pressing
object. In this case, operating programs entered will not be lost.
Day
Characters
blinking:
RESET key
using a
NOTE: in the absence of
mains power supply, the
device will switch off
display backlighting and
deactivate the relay.
RESET with a thin
Ok
Delete
1 Prog
19
EN