Victron energy BlueSolar PWM 12V/5A Manuel page 4

1. Connect the battery - plus and minus.
2. Connect the solar array - plus and minus.
3. Connect the load - plus and minus.
The reverse order applies when deinstalling.
An improper sequence order can damage the BlueSolar PWM Charge Controller!
1. Make sure the battery is charged for the BlueSolar PWM Charge Controller to recognize
the battery type before first installation.
2. The battery cable should be as short as possible to minimize losses.
3. The controller is suitable only for lead-acid, and LiFePO4 batteries.
4. The BlueSolar PWM Charge Controller is suitable only for regulating solar panels. Never
connect another charging source to the charge BlueSolar PWM Charge Controller.