Contour Name Assignment; Wireless Setup - PURE Contour 200i Air Mode D'emploi

Connection
The Connection tab is divided into two main sections, Product Name and Wireless
Network Setup.

Contour name assignment

If you prefer, you can change the name that your network, iTunes and Apple device
uses for Contour:
1. Type the name (e.g. 'Living Room') that you want to assign Contour in the
Product Name box and click Update.
2. Wait for the page to refresh to confirm that the new name has been assigned to
Contour.

Wireless setup

See page 12 for more information on wireless setup.
Manual wireless setup
If your wireless network is not broadcasting an SSID, you will need to configure
your wireless settings manually.
1. Enter the SSID of your router and select the encryption type of your wireless
network from the drop-down list below.
Note: Please check your wireless router configuration to find out the type of
encryption that is being used on your wireless
2. Enter the passphrase/key needed to connect to your network in the box below,
if one is required.
3. Click Connect. The Status LED will then flash red to indicate that Contour is
rebooting. When Contour has started up it will enter Sleep mode.
Product Name
Wireless
Setup
network.
21