Using Airplay To Play Audio; Selecting Airplay As A Source; Playing Audio From An Ipod Touch, Iphone Or Ipad - PURE Contour 200i Air Mode D'emploi

Using AirPlay to play audio

Selecting AirPlay as a source

Press Source on the remote control until the Status LED is white. If the Status
LED is steady white AirPlay has been set up successfully (this can take up to one
minute). If the Status LED is still flashing white after one minute, there is a problem
with Contour's network connection.
Note: See 'Hints and tips' on page 24 for help with troubleshooting Contour
network connectivity issues.

Playing audio from an iPod touch, iPhone or iPad

On your iPod touch, iPhone or iPad, ensure you
are connected to the same wireless network as the
Contour. You should then be able to select your
Contour from the list of AirPlay devices.
Note: The default name assigned to Contour
consists of the word 'Contour' followed by a six digit
code. This six digit code represents the last six digits
of Contour's MAC address, which can be found on
the label on the base of Contour.
On your iPod touch, iPhone or iPad, the AirPlay
symbol will be white when any AirPlay device is
available on the network. The AirPlay symbol will
turn blue when the iPod touch or iPhone is using
Contour as a speaker accessory.
Select the track you wish to play. If Contour is in
Sleep mode, it will wake up and switch the source to
AirPlay. The Status LED will change to white when
AirPlay is active.
14