Nobles TIDY-VAC 6 Manuel De Fonctionnement page 8

English
EN
How To Change or Clean the HEPA Filter
1.
Turn off the main power switch and unplug the power cord from the electrical outlet.
2.
Lift the latch at the front of the machine and lift the lid up
3.
Rotate the HEPA filter clockwise and lift out (Fig.1)
4.
Shake or brush the dust from filter (Fig.2).
5.
Replace the HEPA filter every six months (Fig 3). Note: Do not operate machine without filter installed
HEPA
1
Thermal Protection
The machine is equipped with a thermal cut-out protector. This is designed to protect the machine from overheating should
the airflow be blocked for extended periods. This may occur if the vacuum bag is overfull or if the vacuum hose is blocked.
The vacuum motor will stop before it can get too hot. Should this occur, turn off the machine and unplug the power cord from
the electrical outlet. Remove the dust bag and empty, clean the filters or free any blockage and ensure adequate airflow is
restored. Allow the machine to cool for approximately 45 minutes. To resume operation, plug cord into an electrical outlet and
restart machine.
4
8
2
3
2012
Nobles Tidy-Vac 6 (08-2013)