JB Systems LED VICTORY SCAN MK2 Mode D'emploi page 6

ENGLISH
7. WIRELESS REMOTE CONTROL INPUT: Used to connect RF-8
wireless controller while the unit is used in standalone or
master/slave mode.
8. MAINS INPUT: with IEC socket and integrated fuse holder, connect
the supplied mains cable here.
9. DMX INPUT/OUTPUT: used for DMX512 linking. Use good quality
3pin XLR M/F balanced cable to link the units together.
10. SAFETY EYE: used to attach a safety cable when the unit is rigged
(see paragraph "overhead rigging"
11. COOLING FAN: used to cool the components inside the enclosure.
Make sure to never cover this fan outlet!
MAIN MENU:
 To select any of the functions, press the MENU button up to when the
required one is shown on the display or use the DOWN and UP
buttons to browse the menu.
 Select the function with the ENTER button (the display blinks).
 Use DOWN and UP buttons to change the mode.
 Once the required mode is selected, press the ENTER button to
confirm.
To go back to the main menu without any change press the MENU
button shortly. The main menu is shown in the chart.
DMX Address
Used to set the starting address in a DMX setup.
 Press the MENU button until "Addr" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to change the DMX512 address.
 Once the correct address shows on the display, press the ENTER
button to save it.
To go back to the main menu without any change press the MENU
button shortly.
If you want to go back to normal running mode: press the MENU button
for about 2 seconds.
Channel mode
Used to set the desired channel setup mode.
 Press the MENU button until "ChMd" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to choose 1MSL, 4MSL, 1, 7 or 8ch
(iSolution compatible) mode.
 Once the desired channel setup mode shows on the display, press
the ENTER button to save it.
To go back to the main menu without any change press the MENU
button shortly.
If you want to go back to normal running mode: press the MENU button
for about 2 seconds.
Slave Mode
Used to make the slave unit work in opposite to the master or to
work in complete sync.
 Press the MENU button until "SLMd" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select "SL 1" (normal) or "SL 2" (2
light show) mode.
 Once the mode is selected, press the ENTER button to save it.
To go back to the main menu without any change press the MENU
button shortly.
If you want to go back to normal running mode: press the MENU button
for about 2 seconds.
JB SYSTEMS
®
4/72 LED VICTORYSCAN MK2 / SPINNER
OPERATION MANUAL