Presets - Dedicated Micros dtx300 Manuel D'utilisation

Presets (dtx400/400d.c. only)
To select a pre-programmed preset position, press one of the preset buttons 1 to 8
TO

PRESETS

To programme a preset, first position the camera using UP, DOWN, LEFT & RIGHT arrow
buttons or the joystick. Second set the ZOOM and FOCUS positions. When satisfied with the
position and the picture quality, press and hold set whilst pressing one of the preset buttons 1 to 8
UP TO
PRESET PROGRAM
AND
When this controller is used to drive a Dedicated MicrosType 2050 Dome Camera a new menu
display will appear at this stage, showing a full alphabet and numbers 0 to 9. This can be used to
add an identification legend to the preset. Using the joystick, move the cursor to highlight each
symbol in turn, select the symbol by pressing the preset 1 button. On completion move the cursor
alongside Accept edit and again press the preset 1 button.
If no legend is required just invoke the Accept edit command as described above.
To erase a preset, press and hold set whilst pressing IRIS open (This will erase the last preset) For
example, to erase preset 4, press button 4 then press and hold set whilst pressing IRIS open
ERASE PRESET 4
AND
THEN
dtx 300, 400, 400d.c. Installation Manual Page. 8