Alarm Enable/Disable Receivers With Local Alarm Inputs; To Programme Enable/Disable Local Alarms - Dedicated Micros dtx300 Manuel D'utilisation

Contrôleur de télémétrie
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

6. Alarms (dtx 400/400d.c. only)
Alarm enable/disable for receivers with local alarm inputs
Several Dedicated Micros telemetry receivers provide local alarm capabilities. It is possible to
enable/disable individual alarms using the following commands.

To Programme enable/disable Local Alarms

Press and release the preset button corresponding to the alarm that is to be enabled/disabled.
Press and hold set and TILT up to enable the alarm or TILT down to disable the alarm.
TO ENABLE
UP TO
THEN
AND
ALARMS
TO DISABLE
THEN
AND
UP TO
ALARMS
The same procedure applies if using a dtx 400dc, which is equipped with a joystick for proportional
speed control of d.c. drives. Please ensure that the joystick is not panned during the tilt operation.
For further information on local alarms please refer to the relevant receiver handbook or call
Dedicated Micros.
dtx 300, 400, 400d.c. Installation Manual
Page. 12

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dtx400Dtx400dc

Table des Matières