Twisted Pair Output - Dedicated Micros dtx300 Manuel D'utilisation

7. Twisted Pair Output

The Twisted Pair output sends telemetry signals from the transmitter to the receiver. A video cable
connection is still required. The twisted pair option is normally used to connect a non cable
transmission system i.e. fibre, microwave etc.
The twisted pair option provides a 20mA compatible output, 1200 baud 8 data bits 1 stop bit even
parity.
Connections
NOTE: THE UNITS WILL STILL WORK IF THE CABLES ARE REVERSED
dtx 300, 400, 400d.c. Installation Manual
GREEN CONNECTOR ON
THE REAR OF THE dtx300
AND dtx400 TRANSMITTER
VIDEO CABLE STILL REQUIRED
GREY CONNECTOR ON THE
RECEIVER PRINTED CIRCUIT
BOARD PINS 1 AND 2
Page. 13