Program Menus - Watts Industries Climatic Control-H Manuel D'installation Et D'utilisation

ABSENCE/VACATION mode of operation
Time-limited operation of REDUCED TEMPERTURE mode
Duration can be set between 1 and 24 hours and up to a maximum of 44 days. Upon expiration of this
period the Controller switches over to operating mode
By means of the arrow keys (◄) the cursor is first moved to
The duration of absence can be changed using buttons (+) or (-) .
Example:
Both symbols
To discontinue this mode of operation before time you have to set the remaining time at 13 to
the (-) key.
STOP mode
This mode is used to switch off the system.
The device switches off the system. The Controller software version is indicated on the display for about 3
seconds and then switches off (no indications).
By pressing any of the keys the Controller can be switched on.
ATTENTION: When the Controller is switched off the heating system could freeze!
6.4 P
ROGRAM MENUS
By means of the arrow keys (◄) and (►) you scroll through the program menus. The cursor should be positioned
on the symbol you wish to select.
TIME AND DATE Program menu – setting
In this menu you can set the actual time and date as well as the day of the week.
Using the cursor select
By keys (+) or (-) set the minutes; confirm by pressing (OK).
By keys (+) or (-) set the hour; confirm by pressing (OK).
By keys (+) or (-) set the day of the week; press (OK) to confirm.
PROGRAMMING menu
In this menu you choose the program of the Controller (duration of the periods for operation in reduced
temperature and heating mode), which is to be followed in operating mode
factory set programs from P1 to P9 ( 6.2.1.) and one of the user's programs from U1 to U4.
First you select
indication starts blinking. By the keys (+) or (-) now you can select the program you need and confirm it
by pressing (OK).
User-defined Programs (U1 – U4)
If you choose one of the user programs from U1 to U4, you can program the REDUCED temperature and
NORMAL heating times directly. Proceed as follows:
At 13 the time indication blinks and day 1 is highlighted, while at 7 the time cursor blinks at 0 h on the
symbol (heating mode). Pressing the (-) key you can move the time cursor to the
temperature mode). Then the time cursor jumps to the next hour. Thus NORMAL and REDUCED tempera-
ture cycles are selected using the (+) and (-) keys.
Using arrow keys (◄) and (►) you can select the time in the same manner.
When day 1 programming is completed the time cursor switches automatically to 0:00h of day 2. Thereby
the programmed values for day 1 are stored. Programming other days is done using identical procedure
moving the cursor by pressing (►). When you switch over to programming the next day the program for
the previous day is saved. On completing the programming of the last day 7, the indication first switches to
PPLIMP2350Bb
= 1 hour; = 1 day
and start blinking. The remaining time is displayed at 13.
first and then press the (OK) key.
with the help of the cursor. The indication
.
.
. Then appears on the display at 13.
. You can choose between
appears at 5. Press the (OK) key and the
GB
using
symbol (REDUCED
page 31