Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
I
O
NSTALLATION AND
PERATION
ClimaticControl-H Heating Controller
IMPORTANT!
Before starting work the installer should carefully read this Installation & Operation Manual, and make sure all in-
structions contained therein are understood and observed.
ClimaticControl-H should be mounted, operated and maintained by specially trained personnel only. Personnel in
the course of training are only allowed to handle the product under the supervision of an experienced fitter. Subject
to observation of the above terms, the manufacture shall assume the liability for the equipment as provided by legal
stipulations.
All instructions in this Installation & Operation manual should be observed when working with the control. Any other
application shall not comply with the regulations. The manufacturer shall not be liable in case of incompetent use of
the control. Any modifications and amendments are not allowed for safety reasons. ClimaticControl-H maintenance
may be performed by service shops approved by the manufacturer only.
The functionality of the control depends on the model and equipment. This installation leaflet is part of the product
and has to be obtained.
Subject to technical modification!
1.
APPLICATION
2.
3.
4.
5.
5.1.
5.2.
5.3.
6.
6.1
T
YPES OF OPERATING MODES
6.2
P
ROGRAM MENUS
7.
7.1
7.2
8.
9.
1. APPLICATION
ClimaticControl-H is developed for variable flow temperature control in heating systems particular in low-
temperature installations like floor heating systems. The flow temperature is controlled depending on the out-
side temperature following a heating curve.
Using the controller the operation of a water floor heating system can be adapted to the actual demands of the
system. In particular, the control can be used in apartments where users have their own individual living habits.
A room temperature thermostat can also be connected. The control has a 7-day programmer including 9 fac-
tory set programs and 4 user defined programs.
The control is normally used in conjunction with a hydraulic control unit which includes a circulation pump, a
two- or three-way mixing valve and a valve actuator.
The controllers have been designed for use in dry environments, e.g. in residential rooms, office spaces and
industrial facilities.
Verify that the installation complies with existing regulations before operation to ensure proper use of the instal-
lation.
PPLIMP2350Bb
M
ANUAL
GB
26
27
27
27
28
28
28
29
30
30
31
34
34
35
35
36
page 26
Publicité
Chapitres
Table des Matières
