Garmin ecoRoute HD Mode D'emploi page 2

ecoRoute HD Instructions
The ecoRoute HD device connects to your vehicle's
™
OBD II (On-Board Diagnostics) connector. The ecoRoute
HD device records vehicle data and wirelessly sends the
data to a compatible Garmin GPS device.
For complete information on using the ecoRoute HD
device with your GPS device, refer to the ecoRoute HD
Supplement found at www.garmin.com.
Updating Your GPS Device Software
Before using the ecoRoute HD device with your GPS
device, you may need to update the GPS device software.
1. Go to www.garmin.com, and click Support >
Software.
2. Follow the on-screen instructions to update the
software for your GPS device.
For specific information about updating your GPS device,
refer to the owner's manual for your GPS device found at
www.garmin.com.
OBD II Connector Location

If your vehicle's OBD II connector is in close proximity to
the vehicle's pedals, to avoid the risk of pedal interference,
do not install the ecoRoute HD device in your vehicle.
Return the product to the place of purchase within 7 days
of purchase for a refund.
The location of the OBD II connector varies for each
vehicle. For the best view of the connector, open the driver
door and kneel.
Search the Internet for images that
show where the OBD II connector
is located in your vehicle. The
following are common locations in
which to look for the OBD II connector:
• The OBD II connector is often below the steering
column, between the center console and the driver's
door.
• The OBD II connector might be under a labeled cover.
Remove or open the cover to access the connector.
• The OBD II connector might be under or behind the
ash tray or near the power outlet in the center console.
WaRnInG
OBD II Connector OBD II Connector
Connecting and Mounting the
ecoRoute HD Device

When installing the device in a vehicle, install the device
securely so it does not interfere with the vehicle operating
controls, such as the foot pedals, or the driver's feet.
Interference with the vehicle operating controls or feet can
result in an accident, which could result in injury or death.

Defer to your vehicle's warranty provisions and owner's
instructions for guidance on whether any OBD II
connector product might void or alter your vehicle's
warranty. Garmin is not responsible for any costs or
expenses associated with vehicle repairs or voided
warranties.
The permanent mounting adhesive is extremely difficult
to remove after it is installed.
Before installing the ecoRoute HD device, you must
update the GPS device software and find the OBD II
connector in your vehicle.
1. Connect the ecoRoute HD connector to the OBD II
connector in the vehicle.
ecoRoute HD
connector
2. If securing with double-sided mounting adhesive, clean
the area where you will place the adhesive.
3. Secure the ecoRoute HD device and cable to the
vehicle using the cable ties or double-sided mounting
adhesive. Secure the device away from the foot pedals
and the driver's feet.
RESET key
LED

WaRnInG
CaUtIOn
Notice
Vehicle OBD II connector
ecoRoute HD
device
Cable ties