Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
f there is a problem?
PROBLEM
Water drips from the
holes in the soleplate.
Brown streaks come
through the holes in
the soleplate and stain
the linen.
The soleplate is dirty
or brown and can
stain the linen.
There is little or no
steam.
The soleplate is
scratched or damaged.
Steam or water come
from the iron as you
finish filling the tank.
The spray does not
spray.
Environment
Environment protection first !
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
POSSIBLE C USE
You are using steam while the iron is
not hot enough.
You are using the Shot of Steam
button too often.
You have stored the iron horizontally,
without emptying it and without
setting it to
.
You are using chemical descaling
agents.
You are not using the right type of
water.
Your linen has not been rinsed
sufficiently or you have ironed a new
garment before washing it.
Your are ironing with an
inappropriate temperature selection
(temperature too high).
You are using starch.
The water tank is empty.
Your iron has been used dry for too
long.
You have placed your iron flat on a
metallic rest-plate or ironed over a
zip.
The steam control is not set to
the
position.
The water tank is overfilled.
The water tank is not filled enough.
Wait until the thermostat light goes out.
Wait a few seconds between each use of
the button.
See the section "Storing your iron".
Do not add any descaling agents to the
water in the water tank.
Perform a self-cleaning operation and
consult the chapter "What water should I
use?".
Make sure that your laundry is rinsed
sufficiently in order to remove any
deposits of soap or chemical products on
new clothes.
Clean the soleplate as indicated above.
Select the appropriate program.
Clean the soleplate as indicated above.
lways spray starch onto the reverse
side of the fabric to be ironed.
Fill the water tank.
Carry out a self-clean.
lways set your iron on its heel.
Do not iron over zips.
Check that the steam control is set to
the
Never exceed the Max level.
Fill up the water tank.
14
SOLUTION
position.
EN
FR
ES
Publicité
Table des Matières
